Supporting bar for engine mounts: This picture shows the supporting bar connecting the two engine mounts together. Without the bar, in bumps the weight of the engine puts a lot of load on the chassis and can push them apart.
You are looking at picture 16 of 50 in the Ford F1 picture gallery. For more, follow the links below.
« prev | next » | This Trip | Picture Gallery | Forums | Home
Copyright © Offroaders Club Karachi. Some Rights Reserved.
Comments (2)
You can leave new comments below
imad says:
On September 24, 2007 6:52 AM
This pic has been here a while, don't know how I didn't notice it before, but that bar is not going to do any good. In order to serve its intended purpose, it needs to be dead straight. All the bends in this bar will flex if the frame rails start spreading.
Hamid Omar says:
On October 2, 2007 12:11 AM
This is a torsion steel bar (not a ordinary bar), which flexes with the chassis and hopefully will do it's intended job and will never fail.
Enter Your Comment
Please read comment policy before commenting
Please be considerate of others. Keep comments relevant. Content deemed inappropriate or offensive may be edited and/or deleted. For feedback not pertaining to this picture, please use the forums.